Korusetti makeanvedenhelmistä ja siemenhelmistä
Näin sen teet
Open the loop on the stud earring and insert an eye pin. Close the loop on the stud earring using round nose pliers.
Thread your chosen beads onto the eye pin.
Twist the end of the eye pin to form a loop using round nose pliers, preventing the beads from sliding off.
Put a wax bead onto a round jump ring.
Insert the round jump ring into the loop of the eye pin and close the round jump ring with multi pliers.
Thread a bead tip and a crimp bead onto a beading wire when making the bracelet and the necklace. Squeeze the crimp bead with multi pliers and close the bead tip around the crimp bead as shown in the photo.
Insert the round jump ring into the loop of the bead tip and then insert the fastener into the round jump ring. Close the round jump ring with multi pliers.
Measure a piece of beading wire, large enough for a necklace or a bracelet.
Thread beads onto the beading wire and finish with a bead tip and a crimp bead, following the procedure described earlier. Cut off the excess wire.
This bracelet is made with rocaille seed beads and freshwater pearls on a beading wire.
This finished jewellery set is made with rocaille seed beads and freshwater pearls.
Copyright © Sinelli Oy | Väinö Tannerin tie 3 | 01510 Vantaa | 09-7513 3133 | firstname.lastname@example.org