Viikonloppuetu: Nyt saat 25% alennuksen laajasta puuvillalankojen valikoimastamme. Löydät alennuskoodin täältä

How to make relief designs in handmade bars of soap

SKU#:
v16098

How to make relief designs in handmade bars of soap

SKU#:
v16098

Make your own homemade bars of soap in beautiful colours with relief designs or text prints. Melt the soap base either in a water bath or in the microwave. You will need 100 g soap base, 1 cm soap dye paste and 2-3 drops of essential oil per finished bar of soap. Place your bar of soap in a soap dish, allowing it to dry out between each use.

Oma räätälöintisi
Uusi
Luova idea
How to make relief designs in handmade bars of soap
How to make relief designs in handmade bars of soap

Varastossa 

4,50 €

Yhteenveto
    Uusi
    Luova idea
    Näin sen teet
    Guide step %d
    1
    Weigh 100 g soap base and cut into 3 x 3 cm chunks. Melt in the microwave with 30 second intervals at 80% power and stir between each interval to prevent heat damage. We recommend you use gloves when melting the soap base.
    Guide step %d
    2
    Wash the mould and spray it with rubbing alcohol. Wipe it well to make sure it's completely dry prior to use. Place silicone stamps on the bottom of the moulds and make sure that they are secured to the bottom.
    Guide step %d
    3
    You will need as follows for each finished bar of soap: 100 g soap base, 1 cm soap dye paste and 2-3 drops of essential oil.
    Guide step %d
    4
    Carefully pour the molten soap into the mould, taking care that the silicon stamp at the bottom doesn't move.
    Guide step %d
    5
    Remove any air bubbles from the surface by spraying with rubbing alcohol.
    Guide step %d
    6
    Leave the bars of soap to harden in the mould for 1-2 hours. Carefully remove the silicon stamps without scratching the bars of soap.
    Guide step %d
    7
    Carefully make a hole in the middle of the bar of soap approx. 1 cm from the top edge as shown in the photo. Support the bar of soap on the back to prevent it from breaking. Cut a 50 cm piece of natural hemp, feed it through the hole and tie a knot; one by the soap and one a bit higher up, forming a loop for hanging.

    Lisätietoja

    Make your own homemade bars of soap in beautiful colours with relief designs or text prints. Melt the soap base either in a water bath or in the microwave. You will need 100 g soap base, 1 cm soap dye paste and 2-3 drops of essential oil per finished bar of soap. Place your bar of soap in a soap dish, allowing it to dry out between each use.

    Lisätietoja
    Tuote#:v16098

    Kuvaus

    Copyright © Sinelli Oy | Väinö Tannerin tie 3 | 01510 Vantaa | 09-7513 3133 | asiakaspalvelu@sinelli.fi